Παιδιά καλημέρα, έστω και μετά από τόσο καιρό.
Έχει δοκιμάσει κανείς το governor της Align?
Αξίζει τον κόπο για έναν αρχάριο ή είναι μόνο για 3D κ.λ.π.
Τέλος πάντων να το συνδέσω μια και τό'χω επάνω ή να μην μπω στον κόπο;
Έχω την Τ/Κ Χ9303 η οποία έχει ειδικό πρόγραμμα για governor ξέρει κανείς τίποτε επαυτού;
Ευχαριστώ.
ξερεις αγγλικα ναι?
You have to go to 'DeviceSEL' and select the 'Gear' channel as GOV, the Gyro must be in Aux2. Then you will have Governor Menu, there you just have to put the % for each flying mode. Now you will have to use the Gyro with the GYRO sens menu.
Yes I have done it and it works no problem using the gov menu on Gear. With the Align gov realize unlike other govs that a positive direction in the gov menu will turn on the gov and set the RPM. The Align gov turns off when you go in the negative direction no matter the value! So in the gov mode set all modes to a RPM number that is positive!
Oh and if Gear channel is reveresed then guess what Negative numbers in gov menu turn it on and positive will be off.....
Finally make sure when you calibrate the Align gov to have the gov menu number at +100 as the Align gov reads that as the gov channel end point at initializationδουλευει φανταστικα το ολο setup με την 9303 εγω δουλευω νορμαλ 1700 και idle 2150 και τις κραταει με 30% νιτρο.
αυτα για να παρεις μια γευση μολις ξεκινησεις να το στησεις στειλε μειλ , πμ, η παρε με και τηλ οκ?